Pressure Transducer
Load Cell
Custom Machining
Custom Transducers

Miniature Flush Diaphragm Pressure Transducer

Model: SSW
  • All-welded 17-4 PH Stainless Steel Assembly
  • 3/8– 24 UNF Thread
  • 100 PSI to 10,000 PSI
  • Bonded Strain Gages
  • Liquid or Gas Media
Products Specifications
Pressure Ranges 0-100 psig through 0-10,000 PSI
Non-linearity & Hysteresis +/- 1.0 %  FS 
Non-Repeatability +/-0.1 % FS   
Sensitivity / Output 2 millivolts / Volt
Resolution Infinite
Overload Pressure 150% Range
Temperature, Operating           -65°F to +250°F
Temperature, Compensated 70°F to 170°F
Temperature Effect,  Zero 0.01% FS/°F
Temperature Effect,  Span 0.02% Reading/°F
Strain Gages Type  
Excitation(Calibrated) 5.0 Vdc
Excitation(acceptable) 7 Vdc Maximum
Bridge Insulation Resistance >5000 megohms
Bridge Resistance 350 Ω
Shunt Calibrated Data Data Supplied -excitation & -output
Wiring Code Red + excitation, Black – excitation, White + output, Green -output
Mating connector N/A
Media Liquid or Gas compatible with 17-4PH Stainless Steel
Weight <2 ounces
Installation Torque 300 in-lb Maximum
  5 Ft twisted color coded TFE insulated wires...with a small in-line circuit board 24 inches from sensor
  Customer Supplied Ring  #11 (may be shipped with test o-ring)


  Pressure Transducers   Load Cells   Load Cell Accessories   Services  
  High Precision   Compression Only   Base/Pull Plates   Strain Gauging  
  Miniature Flush Diaphragm   Tension Only   Load Buttons   Re-Calibration  
  Steam Sterilizers   Compression/ Tension   Tongue Shackle   Transducer/Repair  
  Flush Diaphragm   Miniature Load Cell   Yoke Shackle      
  Universal Pressure Transducer   Universal Load Cell          
  Universal Differential   Low Profile Load Cell          
      Thru Hole Design Load Cell          
      Internally Threaded Mini Donut