Pressure Transducer
Load Cell
Instrumentation
Custom Machining
Custom Transducers
 

Flush Diaphragm Pressure Transducer

   
Model: SF
  • Subminiature Wafer Type
  • All Stainless Steel   
 
     
 
   
 
     
 
Products Specifications
Pressure Ranges 0-100 PSI to 0-500 PSI (specify)
Accuracy +/- 1.0 % FS
Repeatability +/- 1.0 % FS
Sensitivity /Output 30 mv/v
Resolution Infinite
Overload Pressure 150% F.S.
   
Temperature, Operating      -65 °F to 275 °F
Temperature, Compensated 60 °F to 160 °F
Temperature Effect,  Zero 0.01 % FS/ °F
Temperature Effect,  Span 0.03 % FS/ °F
   
Strain Gages Type 500 Ohm Semiconductor
Excitation(Calibrated) 5 VDC
Excitation(acceptable) 7 VDC
Bridge Insulation Resistance 5000 megohm
Bridge Resistance Ranges > 150 PSI, 350 ohms
Shunt Calibrated Data  
Wiring Code Red / Black        +/- Input (Excitation)
White / Green    +/- Output (Signal)
Mating connector N/A
   
Media Gas, Non Conductive Liquid
Burst Pressure  
Pressure Port N/A
Material Stainless Steel
   
Dimensions  
Reference  
Termination 5ft TFE Insulated & Shielded Cable
Balance Circuit Board Located 24”
From Transducer.
 


 

 
                 
  Pressure Transducers   Load Cells   Load Cell Accessories   Services  
  High Precision   Compression Only   Base/Pull Plates   Strain Gauging  
  Miniature Flush Diaphragm   Tension Only   Load Buttons   Re-Calibration  
  Steam Sterilizers   Compression/ Tension   Tongue Shackle   Transducer/Repair  
  Flush Diaphragm   Miniature Load Cell   Yoke Shackle      
  Universal Pressure Transducer   Universal Load Cell          
  Universal Differential   Low Profile Load Cell          
      Thru Hole Design Load Cell          
      Internally Threaded Mini Donut          
             
 
                 
 

HOME | ABOUT US | PRODUCTS | SERVICES
SENSORWERKS©2016